User`s guide

WN-5220-S VideoWall User’s Guide
47
8. Set the Wall Size on each
display
Open the Wall Processor menu. Enter the horizontal
and vertical number of displays in the wall. Each
display should show the same horizontal and vertical
wall size.
Each display should show a different Current Unit
value. This value represents its location in the wall.
9. Put each display into Wall
Mode
Move the menu cursor to the Calc wall pos line and
press the ENTER button. This calculates the position
of the selected display within the image and puts the
display into Wall Mode. Each display will now show
only its segment of the overall image.
Do this with each display in the wall and exit the Wall
Processor menu.
10. Fine tune the wall image
If the previous steps were done correctly, the image in
each display should not need to be adjusted by more
than two lines in any direction.
If an adjustment to the image must be made, use the
scaling function in the Zoom menu to move only the
edge that needs adjustment.
11. Save the settings
Open the Save Config menu and save the settings for
each display, as described above in
Step 4 – Save,
Recall, or Reset the Settings
on page 17.
If there are other video sources that will use Big Picture, go through this whole
process for each video source. Then save the settings.