User`s guide

Clarity Visual Systems
November 1998
46
Source Select
Frequency
Phase
Input Level
Position
Zoom
Wall Processor
Color Balance
Curtain
Hours
Save Config
Recall Config
Reset Config
Misc Control
About
Wall Processor
Wall Size:
Horizontal: 002
Vertical: 002
Current Unit: 000
Misc:
[ ] Calc wall pos
[ ] Wall mode
Assign each display a unique address using the Unit
ID knob. (The Group ID setting has no effect on the
display addressing for Big Picture.)
The address of the display in the upper left corner (as
seen from the front)
must
be zero. The addresses of
the other displays must increase left to right, top
bottom, increasing by one for each display.
Therefore, the display in the lower right corner (as
seen from the front)
always
has the highest address.
0 1
2 3
2x2 example
$
(Seen from the
front)
0 1 2
3 4 5
7. Set each display’s address
3x3 example
$
6 7 8