User`s guide

Clarity Visual Systems
November 1998
42
Turning off the System
Turn off the Lamp, Enter Standby Mode
Use the remote to turn off the lamp and enter standby mode. The
main power switch on the back of the power supply is left on and the
unit remains in standby mode until turned on again.
1. Press the remote control OFF
button – or the hard-wired
REMOTE ON/STBY switch – or
the POWER button on the rear
connector panel
The unit is placed in the standby delay mode and the
lamp is shut off and locked out for 3 minutes. The fans
continue to operate during lockout to ensure proper
cooling. Three beeps will sound if an attempt is made to
turn on the units during the 3 minute lockout.
During the standby delay cycle the STBY LED on the rear
connector panel will blink.
Active
Settings
Saved
Memory
Factory
Default
Values
Save
Reset
Recall
Figure 4 Block diagram of memory system