User`s guide

WN-5220-S VideoWall User’s Guide
41
1. Press the remote control MENU
button
The Main menu is displayed.
2. Press the Up/Down arrow keys
Move the cursor to the Save Config (or Recall Config
or Reset Config) selection.
3. Press ENTER
The Save Config (or Recall Config or Reset Config)
menu is displayed.
4. Press the Up/Down arrow keys
to highlight the
upper pair of
arrows
#
##
# $
$$
$
This is the Source selection area. The list of sources
is shown in the right column, with the current
selection preceded by a bullet
•
••
•
and stated next to
the arrow symbols.
5. Press the Left/Right arrow keys
Use the left/right buttons to choose the Source you
want to Save/Recall/Reset.
6. Press the Up/Down arrow keys
to highlight the lower pair of
arrows
#
##
# $
$$
$
This is the Mode selection area, where you will
choose the modes that will be Saved/Recalled/Reset
for the previously selected Source. There is a
separate memory for
each
source in
each
mode.
7. Press the Left/Right arrow keys
Use the left/right buttons to choose the Mode you
want to Save/Recall/Reset. (If the Source is “ALL,”
the only choice for Mode is also “ALL.”)
8. Press the Up/Down arrow keys
to highlight Save (or Recall or
Reset)
Press ENTER. A new menu appears as shown
below.
Save Configuration Sure
#
##
# $
$$
$
PC
#
##
# $
$$
$
ALL
Save
Are you sure?
Yes No
9. Press the Left/Right arrow keys
to highlight Yes
Press ENTER. The settings will be
saved/recalled/reset for the Sources and Modes you
chose.
Shortcut: Unless you have made changes to a source or mode that
you
do not
want to save, it is easiest and safest to Save All sources,
All modes.
Note: Resetting to factory default settings does
not
destroy the saved
settings in memory until you Save them.