User`s guide

WN-5220-S VideoWall User’s Guide
40
Step 4 – Save, Recall, or Reset the Settings
After all adjustments have been made, Save the settings. There is a
separate Save location for each source in each mode – PC at
800x600, PC at 640x480, RGBS at 31.5 MHz, RGBS at 15.75 MHz,
etc. After you have adjusted the displays for one source, save these
settings before going to the next source and adjusting it.
The Save, Recall, and Reset menus look alike and operate in the
same way, so the explanation for Save will tell you how the Recall
and Reset menus operate. (Resetting does
not
overwrite the memory
where settings are saved. See Figure 4 later in this section.)
Source Select
Frequency
Phase
Input Level
Position
Zoom
Color Balance
Curtain
Hours
Save Config
Recall Config
Reset Config
Misc Control
About
Source
Save Configuration
# $
ALL
•
••
•
All
#
##
# $
$$
$
ALL PC
Save MAC
9-PIN
BNC
C-Video
S-Video
Mode
Save Configuration
#
##
# $
$$
$
PC
•
••
•
All
# $
ALL 640x480
Save 800x600