User manual

RetCam Shuttle User Manual and Service Instructions PN 20-000238 Rev. B
System Functions 21
2 System Functions
This section describes some important system functions.
System Installation
Note: Place components and cabling in a manner to prevent inadvertent
hazards to users or equipment.
1. Place the notebook computer on the top of the cart. Open the computer.
2. Install the notebook computer power supply cable from the notebook to the EO
box.
3. Install the USB video cable from the notebook to the EO box.
4. Carefully remove the footswitch from the cart.
5. Install the power cord from the back of the cart to the wall power (supply mains
with protective earth).
WARNING: This equipment should be connected using the power cord supplied by
Clarity.
WARNING: To avoid the risk of electric shock, this equipment must be connected to
a supply mains with protective earth.
Turning ON the RetCam System
1. Turn ON the front power switch on the EO box.
2. Turn ON the main power switch on the back of the EO box. The lamp indicator
light should be illuminated.
3. Power on the notebook computer. The software should initiate.
4. Carefully remove the handpiece from the case or storage drawer.
Note: Store the handpiece in the case or on the holster when not in use.
5. Attach the desired lens piece to the handpiece as shown in Figure 5 and
Figure 6. The display will prompt you when the software is ready.
Note: The system has no internal power supply (no battery) to support image
acquisition after disconnected from a wall outlet. (The notebook computer
can operate using its own battery.)
WARNING: Carefully inspect the lens and clean the lens piece before each use.
DO NOT use if the lens piece has nicks, breaks, scratches, or rough surfaces that
may damage the eye.