User guide

81
A
dvanced Options: Lamp Settings
Auto Lamp On, when checked, turns on the
lamp shortly after AC power is restored. When
not checked, the
Bengal waits for a Lamp On
command from the remote or from RS232.
CAUTION
The lamp must cool down for about
one minute before lighting again. A
rapid on-off-on sequence may
reduce lamp life. Also, the lamp
should be allowed to heat up for at
least five minutes before turning
them off.
Before shutting down due to a missing
source,
Bengal will search each of the
other connectors for an active source. If
another source is not found, Lamp
Saver (if checked) will turn off the lamp
after a specified length of time. When
shut down starts,
Bengal displays the
message below.