User guide

57
5. Remove the defective lamp
 Note: Guide pins are provided to insure the proper
alignment of the lamp and the optical engine.
7. Slide the new lamp into place and tighten the cap-
tive screw.
 Order a spare lamp to replace the one that was used.
8. Replace the access panel.
Resetting the lamp hours
It is a good idea to reset the lamp hours to zero
when you install a new lamp. If you are replacing a
lamp under warranty, you will be asked how many
hours were on the lamp when it failed.
The following menu train will lead you to “Reset
Lamp Hours”.
6. A spare lamp is provided, installed on the filter
housing. Remove the left access panel to
retrieve the lamp