User guide

23
Loosen screw #1 to widen the bottom
of the image.
Loosen screws #2 and #3 to widen the
top of the image.
Adjust screw #3 to square up the top
right.
Adjust screw #2 out to square up the
top left.
Small mirror showing three image adjustment screws
If initial inspection shows that the image is
square, skip this section and go to Electronic align-
ment on page 25.
Squaring the image is be done by adjusting the
small mirror behind the center access panel.
Use the supplied Torx wrench to make the adjust-
ments
Loosening all three screws exactly the same
amount will make the image bigger. Adjusting them
in will make it smaller.
Adjusting screws 2 and 3 the same amount will
adjust the width of the top of the screen.
Adjusting screw 1 will adjust the width of the bot-
tom of the screen.
To access the adjustments on the small mirror,
remove two screws under the center access panel
and remove the panel.