User guide

Installing the Lower Retaining Bracket

The lower retaining bracket is not designed to hold the

weight of the display. Its function is to hold the bottom

of the display securely to the mounting surface and to

allow adjustment of the display to insure perpendicu-

larity.

• Attach the lower retaining bracket to the bottom of

the display with the leg of the angled bracket with

the 4 slotted holes against the bottom of the display

and the other leg between the display and the

mounting surface.

• Mark on the mounting surface to locate the bottom

and ends of the retaining bracket. Remove the

retaining bracket from the display.

• Remove the display from the mounting bracket.

• Install the Lower retaining Bracket to the mounting

surface with appropriate hardware and slots. Locate

the bracket on the mounting surface using the

locating marks made when it was on the display.

• Hang the display on the mounting bracket.

• Secure the display to the lower retaining bracket,

leave the screws a little loose to allow for adjust-

ment. Use the hardware provided.

• Do not push or pull the display to align it with the

slotted holes in the lower retaining bracket. If the

holes do not align, remove the retaining bracket and

repeat the steps to locate the bracket on the mount-

ing surface.

• Use a level or plumb bob to determine perpendicu-

larity. Move the bottom of the display either in or

out till the display hangs perfectly straight. Tighten

the screws on the lower retaining bracket.

Lower retaining bracket installed on the bottom

of the

Bengal. The adjustment slot is shown in

the blow-up picture.

Lower retaining bracket attached to mounting surface.