Product Manual

3
Section 3 Initial Startup
Place the analyzer on a level surface. Allow 80x50 cm on all sides of the analyzer for
access.
Plug the power cord into a power outlet. Press the power switch (16) located on the
back panel to turn the Clarity Urocheck 120C Urine Analyzer on. The Clarity Urocheck
120C Urine Analyzer will run a Self-Test. The analyzer will display the screen shown
below.
Turn the Power Switch on. If the Self-Test passes, the Initial Screen will be shown.
If the Self-Test fails, a Failed Screen will be displayed. The analyzer cannot be
operated. Press the power switch off then on to re-test. Refer to Section 10
Troubleshooting to correct a failure.
Press MENU to access the Test Settings, Analyzer Configuration, Database functions,
Self-Test and QC Test.
Note: Use the arrow keys on the keypad to select Exit or press the
Cancel key when Exit is not available.
Press START to begin strip testing. Press ENTER for ID Admin.