Product Manual

Press START again to begin strip testing. The strip is tested the same as other single

test modes. The results screen will show the sample ID in the ID field.

If Auto-print is Off, press PRINT from the results screen to print results. Press

CANCEL to return to the previous barcode entry screen.

Strip Test – Continuous Test Mode with Barcode reader

If Barcode reader is On and is displayed, samples are tested in batch mode.

Holding the Barcode reader over the barcode on the specimen container, press the

Scan button on the Barcode reader. A red illuminated line will appear over the barcode

to be read. Move the Barcode reader to align the red line over the barcode. When the

Barcode reader beeps the barcode has been scanned. All sample barcode IDs in a

batch are read and stored in memory in sequence. Samples must be run in the same

sequence as scanned. This ensures IDs and samples correspond. Prompts are

displayed to show the next sample to be tested.

Press START to begin the batch mode.

Press CANCEL to return to the Initial screen.

Press ENTER to enter a new screen to edit the Barcode ID.

Press MENU to change Mode

ENTER to confirm

START to test

CLEAR to clear

PRINT or CANCEL

100

000001:

ID Setup

Note: Same patient ID will not be accepted when in continuous input.

02-16-17