Product Manual

Entering Canister Code

When a new canister of strips is required, the analyzer will request that a canister code

is entered from the new canister. The code can be entered manually from the keypad,

or scanned with the Barcode reader, if installed.

At first startup, the Strip Holder will fully extend. The screen below will be displayed.

Scan or manually enter the canister code from the strip canister.

Press CLEAR to move the cursor to the proper digit if you entered an incorrect number.

Edit the number as needed. After the last digit of the correct code is entered, the next

screen will be shown. Press CANCEL to cancel the changes and exit the screen.

If the canister code is incorrect, the following screen will show.

Press CANCEL to exit to the previous screen.

If the canister code is correct, the analyzer will proceed to the Initial Screen.