Administrator’s Guide (Mac OS)

Technical specifications and optimization A-7
MacIPX network initialization
failed; MacIPX is not installed
(error number)
FileMaker Pro Server can’t locate MacIPX. Be sure that the MacIPX control panel is
installed in the Control Panels folder in the System Folder in your startup disk.
MacIPX network initialization failed;
MacIPX version 1.2.1 or greater is required
FileMaker Pro Server detects that an incompatible version of MacIPX is installed. Use
the FileMaker Pro Server Installer to install the correct version of MacIPX. See
“Installing FileMaker Pro Server” on page 1-4 for more information.
MacIPX network initialization failed; not
enough memory
There is insufficient memory to use MacIPX. See “Mac OS system requirements” on
page 1-1 for RAM requirements.
Opened file filename read only with
asynchronous I/O support
Opened file filename with asynchronous
I/O support
Opened file filename read only with
synchronous I/O support
Opened file filename with synchronous
I/O support
Written when the database file specified is opened by FileMaker Pro Server.
FileMaker Pro Server uses asynchronous disk I/O if the disk where the file resides
supports it. If the file is read-only, the message reflects that status. See “Hardware and
network considerations” on page A-1 for more information.
Quit forced; User username forced to close
connection (error number)
These messages indicate that, during a shutdown or disconnect operation, the user didn’t
close the file within the specified time. The user’s connection was then forcibly closed.
Schedule schedulename aborted; the
destination foldername could not be found.
The folder designated for backup files was deleted or moved, so the schedule couldn’t
run. In the Edit Schedules dialog box, specify the Backup to Folder path and run the
schedule again.
Schedule schedulename aborted; the
destination foldername is not writable.
The folder designated for backup files is set to read only, so the schedule couldn’t run.
Check the sharing settings for the folder, or specify another folder in the Edit
Schedules dialog box.
TCP/IP network initialization failed; an
unexpected error occurred (error number).
FileMaker Pro Server can’t initialize TCP/IP.
TCP/IP network initialization failed; not
enough memory
There is insufficient memory to use TCP/IP. See “Mac OS system requirements” on
page 1-1 for RAM requirements.
TCP/IP network initialization failed; Open
Transport is not installed (error number).
FileMaker Pro Server can’t initialize TCP/IP, because it can’t find Open Transport.
Check the installation and setup procedures in the Open Transport documentation and
reinstall, if necessary.
TCP/IP network initialization failed; the
TCP/IP address is already in use or an
address could not be obtained
(error number).
FileMaker Pro Server can’t initialize TCP/IP, because the address specified isn’t
available. If FileMaker Pro is running on the same computer and is set to use TCP/IP,
FileMaker Pro Server is prevented from using the same TCP/IP address. Set
FileMaker Pro to use AppleTalk or MacIPX and relaunch it, or just quit FileMaker Pro.
If FileMaker Pro isn’t running on the same computer, check the Open Transport
documentation, and specify another address, if necessary.
TCP/IP network initialization failed; the
TCP/IP address is configured improperly
(error number).
FileMaker Pro Server can’t initialize TCP/IP, because the address specified isn’t
available. Check the Open Transport documentation, and reconfigure the address,
if necessary.
User username no longer responding,
connection closed
Written when a connected guest’s computer stops communicating with FileMaker Pro
Server due to a network disruption or a software error.
Message Explanation