Installation and New Features Guide (Windows)

A-2 FileMaker Pro Installation and New Features Guide
5. Delete all the files in the <WINDOWS>\<SYSTEM>\WIN32S
subdirectory or the
<SYSTEM>\WIN32S subdirectory in network
installations. Then delete the
WIN32S directory itself.
The above changes take effect the next time you run Windows.
Note <WINDOWS> refers to the Windows installation directory. On a
networked Windows installation, the system directory may be located
on a shared remote volume. If you are removing only WIN32s from your
machine, then you do not need to remove the shared files in
<SYSTEM>
and
<SYSTEM>\WIN32S. Before removing these files from the shared
network, make sure that all users that use Win32s have removed the
references to Win32s from the
SYSTEM.INI file.
Installing Win32s 1.30c
To install or update Win32s:
1. In the Program Manager, click the Main group.
2. Open the 386 Enhanced control panel and change the virtual memory
type to Permanent.
3. Make sure the swap file size is at least 20480 KB.
4. Select Use 32-Bit Disk Access and Use 32-Bit File Access, if available.
Enable 32-Bit
File Access
Set swap file size to
at least 20480 KB
Change virtual
memory type to
Permanent
Enable 32-Bit
Disk Access