Installation and New Features Guide (Windows)
Table Of Contents
- Chapter 1: Installing FileMakerPro
- About this guide
- Registration and customer support
- What you need to install FileMakerPro
- Before you begin
- Installing with Windows95 or WindowsNT4.0
- Installing with Windows3.1, Windowsfor Workgroup...
- Updating your User Dictionary
- Where files are stored on your hard disk
- Adjusting the FileMakerPro cache
- Adjusting network software
- Opening files from previous versions
- Where to go from here
- Chapter 2: New features in FileMaker Pro
- Appendix A: Installing Win32s
Installing FileMaker Pro 1-19
3. Choose a network protocol from the Network Protocol drop-down list.
Note In Windows 3.1, FMIPX32.NET and FMTCP32.NET appear in the
drop-down list.
Changes to this setting don’t take effect until you exit FileMaker Pro and
then start it again.
Changing the frame type
A frame encapsulates packets of information in a recognizable format.
Each packet on the network must conform to a specific frame type to
successfully communicate with other computers on the network. After
you select the network protocol, you must select a frame type.
Note All computers communicating with each other on the network
must use the same frame type. For help in deciding which frame type to
select, see your network administrator.