Developer’s Guide
Table Of Contents
- Chapter 1: Installing FileMaker Pro Developer Edi...
- Chapter 2: Binding solution files
- The binding process—an overview
- Before binding
- Binder and runtime terminology
- Specifying the primary file
- Naming the runtime solution
- Assigning the binding key
- Choosing auxiliary files
- Choosing binding options
- Assigning the three-character extension
- Specifying a location for solution files
- What happens during binding
- Binding cross-platform solutions
- Changing solutions
- Chapter 3: Preparing and managing runtime soluti...
- Chapter 4: Distributing your bundled solution
- Appendix A: Feature comparison—runtime Appendix ...
- Appendix B: About the TechInfo database
- Index
Distributing your bundled solution 4-9
Installing Win32s
To run solution files on Windows 3.1 and Windows for Workgroups
3.11, your end users must first install Win32s 1.30c. Disk copies of
Win32s 1.30c are available from the FileMaker Pro 4.0 folder on the
Developer Edition CD-ROM.
Creating Win32s diskettes
To create Win32s diskettes:
1. Format three 1.44 MB diskettes and name them Disk1, Disk2,
and
Disk3.
2. Drag the contents of the corresponding folders from the FileMaker Pro
4.0 folder on the Developer Edition CD-ROM onto the floppy disks.
Important Disk names, filenames, and paths cannot be modified or the
Win32s installation will fail.
To install Win32s:
1. Open the 386 Enhanced control panel and change the virtual memory
type to Permanent.
2. Make sure the swap file size is at least 20480 KB.
3. Select Use 32-Bit Disk Access and Use 32-Bit File Access, if available.
If any changes were made, they’ll need to restart Windows before
installing Win32s.
Set swap file to at
least 20480 KB
Change virtual
memory type to
Permanent
Enable 32-bit disk access
Enable 32-bit file access