Installation and New Features Guide (Windows)

Table Of Contents
A-8 FileMaker Pro Installation and New Features Guide
For the following SAP parameters, you can enter any value between 0
and 9999, but an application can override the values you set.
For the following RIP parameter, you can enter any value between 0
and 9999.
Default Retry Count Specifies the maximum number of times that SPX attempts to
retransmit a packet before determining that the packets can’t be
sent, and then closes the connection. The default value is 10
times. An application can override the value in this field.
Minimum Retry Count Specifies the minimum number of times that an SPX packet must
be retransmitted. If an application has a retry count setting that is
too low, you can override it by setting this parameter. The default
value is 0 (zero) times.
SAP parameter Function
Query Interval Specifies the time that must elapse before an SAP query is
retransmitted. The default value is 120 ticks, or 2 seconds.
Query Attempts Specifies the number of times that an SAP query is transmitted.
The default value is 3 times.
Receive Buffers Specifies the number of buffers to handle responses returned
from SAP queries. The default is 20 buffers.
RIP parameter Function
Retry Interval Specifies the time that must elapse before a RIP request is
retransmitted. The default value is 0 ticks, which lets the MacIPX
determine what the interval should be, based on the network
configuration.
SPX parameter Function