Installation and New Features Guide (Windows)

Welcome to FileMaker Pro 1-3
Important You must enter the installation code during installation or the
software will not install.
The installation code ensures adherence to the single user license
agreement, which allows for use of one (1) copy of the Software on a
single computer at a time (refer to your Software License). If the code is
invalid or if another copy of the application installed with that same code
is running on the network, the installation program or application launch
stops and the software displays this error message:
“The maximum number of licensed users are currently using this
copy of FileMaker Pro. Please refer to the installation code section of
your Installation and New Features Guide for further instructions.”
If you receive this error message, you have entered a duplicate
installation code. To install FileMaker Pro on multiple computers, you
must have a unique installation code for each user, or obtain a volume
license. You must purchase a copy of FileMaker Pro for each user.
Minimum hardware and software requirements
To install and use FileMaker Pro, you need the CD-ROM in the
FileMaker Pro package and the following minimum equipment
and software:
Windows:
1 an Intel compatible 486/33 PC or higher with 8 MB of RAM (16 MB
of RAM recommended)
1 a hard disk
1 a CD-ROM drive
1 Windows 98, Windows 95, Windows NT 3.51 or later, Windows for
Workgroups 3.11, or Windows 3.1
Note ODBC import and Web publishing are not supported in Windows
3.1 or Windows for Workgroups.
Mac OS:
1 a Macintosh or Mac OS computer with at least 8 MB of RAM (16 MB
recommended)
1 a hard disk
1 a CD-ROM drive
1 System 7.1 or later, or Mac OS 8.0 or later