Installation and New Features Guide (Windows)

Installing FileMaker Pro in the Mac OS 3-5
1 If the selected disk doesn’t have enough space for the files you
select, you see a message. In the Finder software, you can delete
existing files to make more room on the disk. You can also choose
not to install some files (like the tutorial or template files) by
deselecting those files in the scrolling list.
5. Click Install.
If you’ve selected the application, you see the Personalize dialog box.
6. In the Name box, type your name and press the Tab key.
7. Type your company name, if applicable, and press Tab.
If you don’t have a company name, you can put other information
(like your address) in the box or leave it blank.
8. Type your FileMaker Pro installation code.
The installation code is a seventeen-digit number located on either a
two-part sticker attached to the front of the paper CD envelope cover
(North America) or a three-part sticker attached to a separate paper
sheet within the box (International).
Important You must enter the installation code during installation or
the software will not install. See “Installation code” on page 1-2 for
more information.
Check your typing carefully. After you click OK, you can’t change the
name, company, or installation code unless you re-install
FileMaker Pro.
9. Click OK.
The Installer begins copying files. After the selected files are
installed, a final dialog box tells you the installation on your hard disk
was successful.
10. Click Quit to leave the Installer.
If you installed the MacIPX networking software, the final dialog box
allows you to restart your computer. You must restart your computer
before you can use the new network software.
11. If you turned off virus protection and file sharing before installing,
turn them back on now.