Installation and New Features Guide (Windows)

2-16 FileMaker Pro Installation and New Features Guide
Changing the frame type in Windows NT
To change the frame type with IPX/SPX networking:
1. Right-click Network Neighborhood.
2. Select Properties from the menu.
You see the Network dialog box.
3. Click the Protocols tab.
4. Click NWLink IPX/SPX.
5. Click Properties.
6. Select a frame type from the drop-down list.
7. Click OK to apply the frame type.
8. Click OK to close the Network dialog box.
Windows NT prompts you to restart your computer for these new
changes to take effect.
Changing the frame type in Windows 3.1 and Windows for Workgroups
For information on changing the frame type in Windows 3.1 and
Windows for Workgroups, please refer to the documentation that came
with your networking software.
Where to go from here
After you install FileMaker Pro, you can immediately begin working
with the application. Here are some suggestions on where to go in the
documentation to get started:
1 If you’re new to databases or FileMaker Pro, read chapter 1,
“FileMaker Pro basics,” in the FileMaker Pro User’s Guide and
work through the online tutorial, located in the FileMaker Pro 4.1
folder.
1 If you’ve used FileMaker Pro before, read chapter 4 of this guide to
learn about new features available in FileMaker Pro 4.1 and 4.0.
1 If you’re upgrading from FileMaker Pro 4.0, read chapters 4 and 5 of
this guide to learn about new features such as the ODBC import
capability in FileMaker Pro 4.1.