Owner's Manual

Error Displays
If
an
error occurs, one of the
following
messages
is
displayed. Take the measures described below to
eliminate the problem.
USB Device
USB
device cannot be identified. Please unplug the connected
device.
not
supported
This device does not support
USB
Hub.
USB
Device
not
su
orted
Non-supported device
is
connected.
USB
Error
Check
port
Over-current protection. Please unplug the connected
device and then
ACC
OFF.
If
an error display other than the ones described above appears, restart this device.
If
the problem
persists, turn off the power and consult your dealer.
Power cannot be turned on. Fuse is blown.
Nothing happens when
buttons are pressed.
Dis
is
not accurate.
Incorrect wirin
Main unit connectors
are dirty.
Replace a fuse with the same amperage.
If
the
fuse blows in, consult ur dealer.
Wipe the dirt off with a soft cloth moistened
with cleaning alcohol.
No sound heard
The speaker protection Turn down sound volume. Function can also be
circuit
is
operating. restored by turning the power off and
on
again.
(Speaker volume
is
reduced automatically
when the speaker protection circuit operates).
Specifications
Tweeter Output:
Maximum Power: 9W (4.5W
x
2 Driver) x 2ch
Rated Power: 6W (3W x 2 Driver) x 2ch
Speaker Impedance: 6
Q
x 2ch
Analog Output: 4 Vrms (vol
OdB)
Signal to Noise Ratio:
11
OdB
(A-Weighted)
Distortion:
0.01
°/o
Analog
Input: RCA
input
I
Power input
Audio Sense:
Low: RCA-in=4Vrmslpower-in=8Vrms
Mid: RCA-in=2Vrmslpower-in=4Vrms
High: RCA-in=1 Vrmslpower-in=2Vrms
Note:
If
the sound
is
muted again, consult our
service department.
Digital Coaxial Input: 0.5Vp-pi75Q
Digital Optical: Max 96kHzi24Bit/PCM
Power Supply Voltage: 1
0.8-15.6V
DC,
negative
ground
Power Consumption: Less than 15 A
Weight : 0.66
kg
(Main unit)
0.385
kg
(Commander)
Dimensions
I
Main unit:
Tl
(Width) x
1-419
11
(Height)
x4-7112
11
(Depth)
180 (W) x 37 (H) x 116 (D) mm
Dimensions
I
Commander:
3-14115
11
(Width) x 1
..
(Height) x
1-415
11
(Depth)
100 (W) x 26.9 (H) x 46 (D) mm (Commander)
Specifications and design are subject to change without notice for further improvement.
Z3
15