Owner’s manual & Installation manual Mode d’emploi et manuel d’installation Manual de instrucciones y de instalación XC 2510 XC 2410 XC 2110 XC AMPLIFIERS AMPLIFICATEURS XC AMPLIFICADORES XC
English Thank you for purchasing this Clarion product. • Please read this owner’s manual in its entirety before operating this equipment. • After reading this manual, keep it handy, such as in your glove compartment. • Save your sales receipt. The warranty at the end of this manual and your sales receipt are essential for warranty service. FCC Approval This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
1. FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2. PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3. CONTROLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4. OPERATIONS . . . . . . . . . . . . . . . . . . .
English 1. FEATURES The Clarion XC2510, XC2410, and XC2110 amplifiers fit a variety of system configurations and provide these features: • Full frequency response with low distortion and exceptional signal-to-noise performance. • Advanced circuitry design provides bridgeable outputs for use in a variety of applications. • Independent electronic crossovers, each with a 12dB per octave slope and full adjustment range (from 35Hz to 250Hz) to aid in audio system design.
English 2. PRECAUTIONS • Do not operate this product in ways other than those described in this manual. • Do not disassemble or modify this product. • Do not pour liquid or poke foreign objects into the unit. Water and humidity will damage internal circuitry. • If the unit becomes wet, turn off all power and ask your authorized Clarion dealer to clean or service the unit. Failure to observe these precautions may damage your car or the amplifier, and may void the warranty.
English 3.
English 3. CONTROLS XC2110 controls and input connections 1 White (+) White/Black (-) Gray (+) Gray/Black (-) Left Right 2 12 10 11 9 Left (White) Right (Red) 1. HI Input connection cables for CH1 (Front LT), CH2 (Front RT), CH3 (Rear LT), CH4 (Rear RT) 2. LOW Input RCA jacks for CH1 (Front LT), CH2 (Front RT), CH3 (Rear LT), CH4 (Rear RT), Subwoofer 3. Front gain control 4. Front Hi-Pass X-Over control 5. Rear gain control XC2510/XC2410/XC2110 6. Rear Hi-Pass X-Over control 7.
English 4. OPERATIONS Setting the operating level The gain controls allow you to set the nominal operating level of the amplifier from 200mV to 8V for RCA inputs or 600mV to 20V for speaker level inputs. This wide adjustment range accommodates virtually any source unit brand. Improving bass sound The amplifiers feature a narrow-frequency band bass boost circuit (known as “high-Q”). The bass boost control acts much like an equalizer with switchable gain fixed at 50Hz.
English Care and maintenance Cleaning the product Use a soft, dry cloth to gently wipe dust and dirt from the unit. Do not use window cleaners, household cleaners, aerosol sprays, solvents, alcohol, ammonia, or other cleaners. These substances may damage the unit. Servicing the product In the event that trouble arises, never open the case or disassemble the unit. The internal parts are not serviceable by the user. Opening any components will void the warranty.
English • Mount the amplifier on a rigid surface away from subwoofer enclosures or to any area that is prone to vibration. Do not install the amplifier on plastic or on any other combustible material. • For easy system setup, mount the amplifier so that the panel controls are accessible after installation. • Always use great care when attaching anything to a surface! Check clearances on all sides of the planned installation before drilling any holes or installing any screws.
English Power and speaker connections XC2510 Power connector Ground (-) Battery (+12V) Battery (+12V) Ground (-) Power Input Speaker output Front Left (CH1) Front Right (CH2) Rear Left (CH3) Rear Right (CH4) Subwoofer (CH5) Amplifier Turn On Fuse 40A Speaker Output XC2410 Power connector Battery (+12V) Ground (-) Speaker output Front Left (CH1) Front Right (CH2) Rear Left (CH3) Rear Right (CH4) Amplifier Turn On Fuse 40A Speaker Output Power Input XC2110 Power connector Battery (+12V) Ground (-)
Applications Right (Red) This application shows the amplifier in mono operation to drive a subwoofer.
CH1 Front Left English Four-channel stereo system In this application, the XC2410 is used as a four-channel amplifier to drive four full-range speakers in stereo. CH4 Rear Right White/Black Purple/Black White Purple Gray/Black Green/Black Gray Green CH3 Rear Left CH2 Front Right Bridged Mode )N THIS APPLICATION THE 8# CAN BE WIRED FOR "RIDGE -ODE %ACH BRIDGED CHANNEL OF THE 8# can drive ONE full-range 4-ohm speaker. Bridged Bridged \\ (-) Purple/Black // White (+) Gray/B
Single amplifier combination system Gray Black Purple CH1 FR Left White/Black White Gray/Black CH2 FR Right Gray Green/Black Purple/Black Purple Setting the gain Black CH4 RR Right Green Yellow/Black CH3 RR Left After completing the installation, follow these steps to set the gain control and perform the final system checks. 1. Turn the gain control all the way counterclockwise. 2. Turn the ignition switch on.
English 3. Turn the source unit on. 4. Set all tone or equalization controls to flat positions and turn loudness off. 5. Play music content and set the volume control to 75% of full level. Note: If the system uses an equalizer, set all frequency controls to the flat position. 6. Slowly increase the gain control. Stop when you hear a slight audio distortion. Setting the crossover Clarion amplifiers feature fully-adjustable crossovers. 1.
English 6. TROUBLESHOOTING No Audio • Low or no remote turn-on voltage: check remote connections at the amplifier and source unit. • Blown amplifier fuse: replace with a new fast-blow fuse (same rating). • Power wires not connected: check battery and ground wiring at the amplifier and check the battery connections. • Speaker leads shorted: check speaker continuity to ground; it should not show a common ground.
hf"'W clarion GARANTIE LIMITEE DE 1 AN CLARION Pour le Canada et les Etats-Unis seulement Ce produit Clarion vendu par un marchand autorise Clarion est garanti contre tous defauts de materiel et de fabrication pour une duree d'un (1) an a compter de Ia date de vente initiale lorsque l'achat est effectue chez un marchand autorise Clarion; les items tels les piles sont couverts par une garantie de 6 mois suivants Ia date d'achat.
281-0639-01 2008/9 clarion" CLARION 1 YEAR LIMITED WARRANTY For USA and Canada only This Clarion product purchased from an authorized Clarion dealer are warranted against all defects in materials and workmanship for a period of one (1) year from the date of original purchase other than consumable parts, such as the battery pack, which are covered for 6 months from the date of purchase, when purchased from AND installed by an authorized Clarion dealer.
