Owner's Manual
Table Of Contents
Connecting the parking brake cord
Connect the cord to parking brake lamp ground
in
the meter panel.
Note:
• Connecting the parking brake cord to lamp ground allows you to watch iPod video/DVD
video/
AV
input when the parking brake is engaged.
• When the parking brake cord is not connected, the monitor will
not
show any video
sources.
•
If
"AUDIO ONLY" appears on the screen
just
after turning on the
ACe
power
of
the
car,
release the parking brake while confirming safety,
and
then engage the parking brake
again.
How to attach the electro-tap
1.
Place the Parking brake cord at the stopper, and
fold it back
in
the direction of the arrow.
2.
Pass the Parking brake signal cord through, and
fold it back
in
the direction of the arrow.
Parking brake
s;gJilr
Parking brake cord
(G
rass-gree
n)
Stopper
Parking brake
signal cord
...
/
~
cord to battery
Parking brake cord
(G
rass-green)
Connecting the accessories
• Connecting to the external amplifier
The external amplifiers can be connected to the 6 channel RCA output connections.
Ensure that the connectors are not grounded or shorted to prevent damage to the unit.
• Connecting to iPod device
The iPod device can be connected to dedicated iPod connection on the main unit.
For detailed information, refer to the instruction sheet or manual for the iPod cable.
Note:
• This unit may not support all functions
of
all iPod devices
• The iPod connection will charge
your
iPod unless the iPod battery is completely
depleted.
If
the specified cord
of
the cellular phone
is
connected to the phone interrupt cord
of
the
main unit, the audio mute is activated when cellular phone
in
use.
• Connecting to XM Satellite Radio Receiver
When a
XM
Satellite Radio Receiver is to be connected, use the dedicated connector.
For detailed information,referto the instruction manual of the XM Satellite Radio
Receiver.
VZ309
35