Owner's Manual

Setting up the screen size
DVD Video Player Operations
LEVEL7
NC-17
(NO ONE 17 AND
UNDER ADMITTED)
LEVEL6 R
(RESTRICTED)
LEVEL4 PG13
(PARENTS STRONGLY
CAUTIONED)
LEVEL3
PG
(PARENTAL GUIDANCE
SUGGESTED)
LEVEL1 G
(GENERAL AUDIENCES)
1. Select Rating Menu screen while in
SETUP mode. Select Set Password.
Enter 4-digit password. Press
[ENT] enter
button to confirm.
2. If you forget the password, enter 0000 to
reset a new password. Press
[ENT] to
confirm Select Set Password again. Enter
new password and press enter button.
Set up Mise Menu
• The contents that the parental level restricts
vary with the country code.
Note: The rating can be selected only under
the password unlocked status,
and the
limits can be
set only under the password
locked status.
Set up the password for parental level
lock
The relationship between DVD video rating
codes and parental level are shown in the table
below. Use this table when setting the parental
level.
This function allows displaying the important
part of image fully on the screen. In some
cases, image is displayed while being panned
(scrolled).
• When watching a wide type through a
wide type of the rear view monitor (16:9)
The leftmost and rightmost areas of the screen
are not cut off.
4:3
A CAUTION
16:9
For your safety, the driver should not insert
or eject a disc, or operate the controls
while driving.
In DVD video menu display select the aspect
ratio "16:9" for wide screen
or "4:3" for normal
dispaly.
·When watching a wide type through
a conventional type of the rear view
monitor (4:3)
The leftmost and rightmost areas of the screen
are cut off.
Set up the audio language
1. Select Audio Menu screen of the DVD while
in SETUP mode. Select a desired language
by using
[T] [£] key. Press [ENT] enter to
confirm.
Set up the subtitle language
1. Select Language Menu screen while in
SETUP mode. Select a desired subtitle
language by using
[T] [£] key. Press [ENT]
enter to confirm.
Set rating for parental level control
1. Select Rating Menu screen while in
SETUP mode. Set rating by using numbers
(0-9) on the remote control key panel.
* The factory default setting is "8"
Select
Yes to return to default (original settings).
Starting DVD system play
Note: Refer to the diagram in "CONTROLS"
chapter.
1. To load a disc:
Press the
[OPEN] button to flip down
the front panel. Insert the disc into the slot.
Note:
• Never insert foreign objects into the disc
insertion slot.
• If the disc is not inserted easily, there maybe
another disc in the mechanism
or the unit may
require service.
• Bcm (single play) discs cannot be used.
16
VZ309