Owner's Manual

6. OPERATIONS
Basic Op~e:..:ra::.:t:.:..:io::..:n:..:.;s=-- _
Note:
• Be
sure to read this chapter referring to the
chapter
"3. CONTROLS"
A CAUTION
When the unit is turned on, starting and
stopping the engine with its volume raised to
the maximum level may harm your hearing.
Be
careful about adjusting the volume.
Turning ON and OFF the power
Note:
• Start the engine before using this unit.
• Be careful about using this unit for a long time
without running the engine. If you drain the
car's battery too
far, you may not be able to
start the engine and this can reduce the
service life of the battery.
1. Start the engine. The power button 1knob
illumination
on the unit will light up.
~ EngineON
~ position
2. Press the [c>] power button to turn ON
the power.
3. To turn OFF the power, press and hold the
[c>] power button for more than 2 seconds.
Selecting a mode
1. Press the [SRC] button to display the
Source menu: Radio, Disc, USB, AUX-In,
SAT, iPod.
*External equipment not connected to this unit
is not displayed.
Adjusting the volume
1. Turn the volume knob to adjust the volume.
Clockwise: Increases the volume.
Counter- clockwise: Decreases the volume.
• The volume level indicated
in the display is
in a range from 0 (min.) to 40 (max.).
A CAUTION
While driving, keep the volume level at which
external sounds can be heard.
VZ309
Adjusting the audio
1. Press the VOLUME knob to access the
audio menu.
2. Press the knob repeatly to move through
the list of the menu options: Bass
1Treble 1
Balance IFader. Rotate the knob to adjust
the settings.
Adjusting the clock
1. Press [SET] button for more than 2 seconds.
Minute display blinks. Rotate the volume knob
to set minutes.
2. Press volume knob once. Hour display blinks.
Rotate the volume knob to set hour.
3. Press [SET] to confirm.
Adjusting the setting
Press [SET] to enter setting menu mode.
Continue press the button until you reach the
desired mode.
Mode comes
in the following order:
Equalizer - Loud
Set- Beep Set -12/24 Mode
- Mirror
Image- VOL Mode-A-VOL-Sub LPF
- Area Set
-Ox/Local -Bass Freq
- Treble Freq
The following procedures assume you have
already accessed the menu.
13