Installation manual


NX404
English
Quick start guide
English
Installing The GPS Antenna
WARNING
s Do not install the GPS antenna in a place where it may interfere with the operation of the
airbag or hinder the driver’s visual range.
s Do not use the navigation system with the GPS antenna cord cut off. The power cables in the
cord may be short-circuited.
Note:
s Thesupplied GPS antenna is for installing inside thevehicle. Donot install it outside the
vehicle.
s InstalltheGPSantennamorethan50cmawayfromthemainunit,otheraudiodevicessuch
asCDplayer,andaradardetector.Ifitisinstallednearthesedevices,GPSreceptionmaybe
impaired.
s
To improvetheGPSsignalreception,installtheGPSantennahorizontallyonaflatplane.
s Donotwaxor paint the cover oftheGPS antenna.This mayreducetheperformanceofthe
GPSantenna.
s Install the GPSantennaatleast10cmawayfromthewindshield.
s Wipe off thedirtofthemountingsurf
acebeforeinstallingtheGPSantenna.
GPS antenna
s Mount the GPS antenna.
the passenger side dashboard
where GPS signal interruption is
minimized.
s Wire the GPS antenna cord.
Fasten the cord using the cord
holders.
Cord holder
Double-sided tape
Bottom face of the GPS antenna
s Stick the double-sided tape to the bottom
face of the GPS antenna.
Cautions on Wiring
ʾƖ½ËÍʽÌÇÌÍÊÆÌÀ½ÈÇϽÊÇŰº½¾ÇʽÏÁÊÁÆ¿Ɩ
ʿƖ½ȹÊÌÁ»ÍĹÊÄÑ»¹Ê½¾ÍÄÏÀ½Ê½ÑÇÍÊÇÍ̽ÌÀ½ÏÁʽËƖ
Keep them well away from the engine, and exhaust pipe, etc. Heat may
damage the wires.
3. If the fuse should blow, check to see if the wiring is correct.
If a fuse is blown, replace it with a new one of the same amperage rating
¹ËÌÀ½ÇÊÁ¿ÁƹÄƼʾ˂ƽƖ
4. To replace the fuse, remove the old fuse on the back of the unit and
insert the new one. (Figure 7)
NOTE:
There are various types of fuse holder. Do not let the battery side touch other metal parts.
Figure 7
Í˽Ƽʾ˂ƽ
After the connection, fix the cord by a clamp or insulation
tape for protection.
Fuse holder
CAUTION