Owner`s manual

16 OHM106/156
English
Install the ceiling bracket and cables
1. Screw the ceiling bracket to the beam or plywood.
Ceiling bracket and monitor
2. Cut a one-inch hole in the headliner along the backside of the ceiling bracket for the
cables to pass through.
3. Route the cables through the hole to the location of the audio/video source(s).
4. Identify the dome light wires in the vehicle and connect them to the corresponding
dome light wire on the overhead monitor system.
5. Plug in the audio/video source cables and the power harness into the overhead
monitor system.
Ceiling bracket
4-6 screws
(not included)
4 screws Max 12
(included)
OHM.pmd 2006-02-28, 13:0016