Installation manual

English
8
NX502A
Installing The Main Unit
This unit is designed for xed installation in the dashboard.
1. When installing the main unit in NISSAN vehicles, use the parts attached to the unit (see “
NISSAN”). When installing the main unit in TOYOTA vehicles, use the parts attached to the
vehicle (see “ TOYOTA”).
2. Wire as shown in “Wire Connection”.
3. Reassemble and secure the unit in the dashboard and set the face panel and center panel.
Mounting Screw Holes (Side View of the Main Unit)
NISSAN
6-Spacer (thickness: 1 mm)
8-Hexagonal screw (M5 × 6)
Center Panel *1
Screws marked
and mounting bracket are attached to the vehicle.
NISSAN
TOYOTA
6-Flat head screw (M5 × 6)
(attached to the main unit)
Mounting bracket
(1 pair for the left and right sides)
Mounting bracket
(1 pair for the left and right sides)
TOYOTA
*2
Installation Guide
Cautions On Wiring
• Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
• Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the wiring is correct. If a fuse is blown, replace it with a
new one of the same specication as the original.
• To replace the fuse, remove the old fuse of the power supply cord and insert the new one.
Note:
• Therearevarioustypesoffuseholder.Donotletthebatterysidetouchothermetalparts.
Note:
*1Somepanelopeningsaretoosmallfortheunitdependingonthevehicletypeandmodel.In
suchacase,trimtheupperandlowersidesofthepanelframebyabout0.5to1.5mmsothe
unitcanbeinsertedsmoothly.
*2Ifahookontheinstallationbracketinterfereswiththeunit,bendandflattenitwithanipperor
similartool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modication. (Trimming, lling, etc.)
Typical Mounting Brackets
In some cases the center panel may require modication. (Trimming, lling, etc.)
Afx the screws to the
marks.
• After the connection, x the cord by a clamp or insulation tape for protection.
Fuse (15A FUSE)
Fuse holder
Example 1-3
Installation Guide