Installation manual

English
3
NX502A
[POWER/VOL] Knob
• Press to power on the system when ignition on.
• When power on, short press to mute the volume.
• Rotate the knob to increase or decrease the volume.
• Press and hold this key more than 1 second to turn off the system.
[ ALL ] ALL MENU Button
• Short press to show/exit shortcut menu.
• Long press to show/exit main source menu.
[ ] NAVI/AV Button
• Press to enter navigation mode;
• Press again to return current source.
[ ] EJECT Button
• Press to eject disc.
[ MIC ] Hole
• Internal microphone
[RESET] Button
• Press to load original settings.
 Note:Whenthe[RESET]buttonispressed,frequenciesofradiostations,titles,etc.stored
inmemoryarecleared.
Operational Panel
AUX Jack
SD Card Slot
Dummy SD card
already inserted in
this unit for prevent
misinsertion of micro
SD card.
Please remove the
dummy SD card before
inserting SD card. .
[ ALL ] ALL MENU
[MIC]
Disc Slot
[ ]
EJECT
RESET
[
] NAVI/AV
[POWER/VOL]
Micro SD card slot
Only navigation map card is available and don't
remove it when unit is power on.
Selecting a Source
Turning the Power On
Start the engine. The power is supplied to
this unit.
Press [POWER/VOL] button on the panel to
turn on the unit.
Long press [ ALL ] button on the PANEL to show main source menu.
Touch [ - ] on the bottom of screen to show front zone sources.
Change page by dragging left or right or touching other [ - ] buttons.
Touch the icons on the screen to enter corresponding work mode, such as Disc mode, Tuner
mode, Telephone mode, etc.