Installation guide

13
English
NX302E
Cautions On Wiring
• Be sure to turn the power off before wiring. Be particularly careful where you route the wires.
• Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.
• If the fuse should blow, check to see if the wiring is correct. If a fuse is blown, replace it with a
new one of the same specication as the original.
• To replace the fuse, remove the old fuse of the power supply cord and insert the new one.
Note:
• Therearevarioustypesoffuseholder.Donotletthebatterysidetouchothermetalparts.
Note:
*1Somepanelopeningsaretoosmallfortheunitdependingonthevehicletypeandmodel.In
suchacase,trimtheupperandlowersidesofthepanelframebyabout0.5to1.5mmsothe
unitcanbeinsertedsmoothly.
*2Ifahookontheinstallationbracketinterfereswiththeunit,bendandflattenitwithanipperor
similartool.
Vehicles other than NISSAN and TOYOTA
In some cases the center panel may require modication. (Trimming, lling, etc.)
Typical Mounting Brackets
In some cases the center panel may require modication. (Trimming, lling, etc.)
Afx the screws to the
marks.
• After the connection, x the cord by a clamp or insulation tape for protection.
Fuse (15A FUSE)
Fuse holder
Example 1-3
Installation Guide