Owner's Manual
Table Of Contents
- Owners Manual
- Using This Manual
- Proper Handling
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Basic Operation
- Entering a Destination
- Route Guidance
- System Settings
- Favorite & Frequent Menu
- Troubleshooting
- Messages
- About Positioning Errors
- Specs
- Installation Manual
- Warranty
Wire Connection
Notes on wire connection
When connecting the plugs and sleeves, be sure to insert the plug until
it
locks securely. After
completing connections, fasten the cords using cord clamps and tapes.
Cut 5 mm.
Female~-H'
~Male
~",,--==:=-)(=)
......
~=
Sleeve
---.I
®@I====
I
If the male knob is
in
the shape shown at
@,
cut the female sleeve about 5 mm.
Example
of
connecting reverse gear
or
handbrake signal cord
Connect each signal cord using the supplied electro-taps.
From this unit
Tighten with the vehicle side screw and fasten
securely
to
the vehicle metal part.
3 Electro-tap
1.
Place the cord from this unit at the stopper, and fold it back
in
the direction of the arrow.
2.
Pass the vehicle signal cord through, and fold
it
back
in
the direction of the arrow.
Vehicle and main unit signal cord
Stopper Power supply cord from this unit
J
Vehicle and main unit signal cord
~
~po~er
supply cord from this unit
Example
of
relay usage
Use a special installation kit (relay cord kit), sold separately, prepared specifically for your model. For
applicable models, consult the dealer where you purchased this unit.
Note:
When connecting the main
power
supply cord (yellow)
of
the main unit, connect it to a spare terminal
of
this unit.
(Yellow) (Yellow)
~
...
CETlE~8m=ai=n=u=n=it=====si
Relay cord (Sold separately)
Conforms to EIAJ standard (CP2501)
Ground cord from this unit
1-..:::::----------------------,
I
~
10
NAX970HD