Owner's Manual
Table Of Contents
- Owners Manual
- Using This Manual
- Proper Handling
- Table of Contents
- Supplied Accessories
- Parts & Controls
- Basic Operation
- Entering a Destination
- Route Guidance
- System Settings
- Favorite & Frequent Menu
- Troubleshooting
- Messages
- About Positioning Errors
- Specs
- Installation Manual
- Warranty
Connecting the Speed Sensor
IMPORTANT
Take care when connecting to the
EC
(Engine Control Computer) vehicle speed signal cable/cord.
1.
Confirm the position of the
EC
(Engine Control Computer) and the vehicle speed signal cable
referring
to
your car make/model.
2.
Remove the vehicle parts, and confirm the position of the vehicle speed signal line of the EC.
3.
Connect the vehicle speed signal line and the speed sensor connection cord of the power supply
harness of this unit using the electro-tap (for speed sensor).
4.
Connect the negative terminal of the battery and start the engine.
Drive the vehicle slowly and check that the signals are proportional
to
the vehicle speed and
are
correctly detected
by
displaying the connection check screen (see the "System Check" section of the
operation manual).
Engine control computer (EC)
Speed sensor connection cord
EC vehicle speed signal cable
{~
__
~~~~
Vehicle speed harness
f~!
4 Electro-tap (for speed sensor)
8
NAX970HD