Owner's Manual

Safety Precautions
ACAUTION
• Do not install the system in the locations
described below. This may cause a fire
accident or electrical shock: '
A location exposed
to rain or dust.
A
location interfering with the driver's
visual range or operation of the vehicle.
An unstable location,
or where the system
may fall.
• Do
not install this unit in a place exposed to
direct sunlight, heat or a place where the
vent holes
or heat radiation holes are
covered.
• When
you install the antenna, mount it in a
place where
the elements of the antenna do
not protrude beyond the edge of the front,
back, left and
right of the vehicle.
If it comes in
contact with pedestrians, it
may cause an accident.
Installation Notes
AWARNING
• Please note the position of pipes, tanks
and electrical
wirings before installing
the unit into the vehicle; failure in
avoiding these may cause a fire or
malfunction.
A CAUTION
• Use only the supplied parts.
• If unspecified parts are used, they may
cause damage.
•
Any holes made in the body of the vehicle
should be sealed with a silicon adhesive.
• If exhaust fumes
or water penetrates into
the vehicle, this may cause an accident.
•
Faste~ the bolts securely when installing
the Unit. If
the bolts are loose an accident or
malfunction could occur.
Connection Notes
AWARNING
• Loom all cables according to the
instruction manual, so as not to hinder
operation.
• Wire the
connecting cords/cables away
from high temperature areas. If the
coatings of the cables melt, it could
cause an accident/fire by a short circuit.
Take care when
wiring in the engine
compartment.
• When
wiring the connecting cables in a
vehicle with an airbag system, never feed
the cables
through a place where it may
affect the operation
of the airbag.
• An airbag
not operating correctly in an
emergency may cause increased injury.
ACAUTION I
• Verify wires with a digital multi-meter prior
to making any connections. Many new
v~hic.les use multiplexed and/or low voltage
Circuits that can be damaged
if a test light
or logic probe is used.
• Connect cables appropriately. If a
wrong
connection is made, this may cause a fire or
accident.
• When p.assing cables
through the body of
the vehicle, use non-conductive grommets.
• If the.
coati~gs of the cables are worn out by
rubbing, this may cause an accident, fire or
a short circuit.
•
After wiring cables, fix them with insulation
tape.
• Be sure
to switch off the vehicle when
connecting or disconnecting cords to/from
the
un~t, otherwise an electric shock, injury
or accident may occur.
4 NAX970HD