Owner`s manual

30 VRX848RVD/VRX743R
English
Owner’s manual
Basic Operations
● Setting the car speaker output for the
cellular phone
∗ The factory default setting is “RIGHT”.
∗ To output the telephone calls, set the cellular
phone interrupt to ON.
2-1. Touch the [z] key.
2-2. Touch the [TEL SP] key to select “LEFT”
and “RIGHT”.
• LEFT:
Telephone calls can be heard on the left
speaker connected to this unit.
• RIGHT:
Telephone calls can be heard on the right
speaker connected to this unit.
Note:
• During cellular phone interrupt, speakers setting
is impossible.
● Cellular phone interrupt setting
If you connect this unit and your cellular phone
with a separately sold cable, you can listen to
your telephone calls on your car speakers.
∗ The factory default setting is “OFF”.
2-1. Touch the [z] key.
2-2. Touch the [TEL SWITCH] key to select
“ON”, “OFF” and “MUTE”.
• OFF:
This unit continues normal operation even
when the cellular phone is used.
Note:
• When the setting is OFF, disconnect the
cellular phone from the cable or turn off the
power of the cellular phone.
• ON:
You can listen to your telephone calls from
the speakers connected to this unit.
∗ When listening to your calls on your car
speakers, you can adjust the volume by
operating the [VOL] button.
• MUTE:
The sound from this unit is muted during
telephone calls.
∗ This function is not compatible with all cellular
telepones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
Listening to the radio
1. Press the [FUNC] button and select the
Radio mode. The frequency is displayed.
2. Press the [BAND] button and select the radio
band. Each time the button is pressed, the
radio reception band changes in the
following order:
FM1 ➜ FM2 ➜ FM3 ➜ AM (MW/LW) ➜ FM1...
3. Press the [a] or [d] button to tune in the
desired station.
Seek tuning
There are 2 types of seek tuning: DX SEEK and
LOCAL SEEK.
DX SEEK can tune in to receivable broadcast
stations; LOCAL SEEK can tune in to only
broadcast stations with a good reception
condition.
1. Press the [BAND] button and select the
desired band. (FM or AM (MW, LW))
2. Tune in to a station.
∗ If “MANU” is lit in the display press and hold
the [BAND] button for 1 second or longer.
“MANU” in the display goes off and seek
tuning is now available.
∗ If “TA” is lit in the display, TP stations are
automatically sought.
● DX SEEK
Press the [a] or [d] button to automatically
seek a station.
When the [d] button is pressed, the station is
sought in the direction of higher frequencies; if
the [a] button is pressed, the station is sought
in the direction of lower frequencies.
∗ When seek tuning starts, “DX SEEK” appears
in the display.
● LOCAL SEEK
If you press and hold the [a] or [d] button for
1 second or longer, local seek tuning is carried
out. Broadcast stations with good reception
sensitivity are selected.
∗ When local seeking starts, “LO SEEK”
appears in the display.
Manual tuning
There are 2 ways available: Quick tuning and
step tuning.
When you are in the step tuning mode, the
frequency changes one step at a time. In quick
tuning mode, you can quickly tune the desired
frequency.
Radio Operations