Owner`s manual

VRX848RVD/VRX743R 29
English
Owner’s manual
Basic Operations
2-ZONE: 2 (rear monitor lock)
1. Press the [ADJ] button to display the
ADJUST MODE menu.
2. Touch the [MONITOR] key.
3. Touch the [REAR MONI LOCK] key and the
[ON] key.
4. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
5. To cancel the monitor lock, press [ADJ]
button, touch the [REAR MONI LOCK] key
and the [OFF] key.
6. Touch the [RTN] key, [ESC] key, or press the
[ADJ] button.
The monitor lock is now canceled.
Adjusting the GENERAL
1. Press the [ADJ] button, then touch the
[GENERAL] key to display the GENERAL
setting menu.
2. Touch the item you wish to set.
∗ To switch to the next menu, touch the [z]
key.
∗ When settings are completed, touch the [RTN]
key, [ESC] key, or press the [ADJ] button.
● Setting the BEEP
∗ The sound heard when you make operations is
called “beep”. The unit can be set up so that it
does not produce this beep sound.
∗ The factory default setting is “BEEP ON”.
2-1. Touch the [BEEP] key to select “ON” and
“OFF”.
● Setting the button illumination
∗ The factory default setting is “RED” (red).
2-1. Touch the [KEY ILLUMI] key to select
“RED” (red) or “GREEN” (green).
● Anti-theft indicator
The red Anti-theft indicator is a function for
preventing theft. When the DCP is removed
from the unit, this indicator blinks.
∗ The factory default setting is “OFF”.
2-1. Touch the [BLINK LED] key to select “ON”
and “OFF”.
● Setting the Auto Panel
When you remove or attach the DCP, you can
set the liquid crystal panel automatically housing
or opening.
∗ The factory default setting is “OFF”.
2-1. Touch the [AUTO PANEL] key to set “ON”,
“OFF” or “CLOSE”.
ON: The liquid crystal panel houses
automatically after removing the
DCP.
And the liquid crystal panel open
automatically after attaching the
DCP.
OFF: Normal operation.
CLOSE: The liquid crystal panel houses
automatically after removing the
DCP.
● Switching CONNECT (connect)
Make the following settings when an external
device is connected to the Visual terminal.
NAX DV: when a Clarion navigation system
(NAX943DV) is connected
OTHR NVG:
when a Clarion navigation system
(NAX9500E) is connected
COMPO: when a navigation system is
connected
∗ When a navigation system is
connected, use the monitor lock
function. Locking the monitor locks
the screen size in F.WIDE mode (full
wide) and the VTR system to NTSC.
OTHERS: for external devices other than a
navigation system; when connecting
a CCD camera
NONE: when no external devices are
connected
∗ The factory default setting is “NONE”.
2-1. Touch the [CONNECT] key to select “NAX
DV”, “OTHR NVG”, “COMPO”, “OTHERS”
or “NONE”.
● Time setting in air conditioner operation
mode
This setting can be used to adjust the time the
panel stays in the horizontal position when in
the air conditioner operation mode.
∗ The factory default setting is “10s”.
2-1. Touch the [HVAC MODE] key to set to “5s,”
“10s,” or “30s.”