User Guide

SOURCE COMMANDER MSS430

Press and hold the Power button for 2 to 3 seconds to

power down the monitor at each of the Control Stations.

Mounting Bezel

Outer mounting bezel around each Control Station allows

for easy installation. (see page 6 for intallation informa-

tion).

SOURCE SELECT Button

Press the SOURCE SELECT button one or more times

to step through the different Audio/Video inputs. Each

LED illuminates to confirm the source selected.

POWER Button

When ignition is applied to the MSS430’s ignition lead,

all control stations are automatically set into the Stand-By

mode (no power output from the monitor’s power con-

nector). Press the POWER button on any Control Station

and the source LED will illuminate and the monitor will

power on.

NOTE: Control Stations

a).If the Ignition is shuts down while the Control Stations

are in use, the Control Stations will

not automatically

turn on when the ignition is activated again. Press the

Power button on the Control Station again. The

Control Station will power up and

remember the last

source selected.