User Guide

OWNER’S MANUAL/INSTALLATION GUIDE
11
3
A/V INPUT 3 (3 -RCA Jacks)
Same as A/V Input 1. Use these jacks to connect a third
video source.
4
A/V INPUT 4 (3 -RCA Jacks)
Same as A/V Input 1. Use these jacks to connect a fourth
video source.
NOTE: When using a optional Clarion Rear Vision
Camera, the video connection must be connected to A/V
Input 4 to function properly with the reverse wire. See
Figure 7 on page 8 for connection configuration.
When +12Vdc is applied to the reverse wire (Pin 4), the
MSS430 will automatically override Control Station 1’s
video selection and switch directly to A/V Input 4. The
LED indicator will blink to show that the reverse function
is active. The video signal will automatically override
any other selection that is being viewed on Monitor 1.
When voltage is removed from the reverse wire, the moni-
tor will automatically switch back to the original source
selected.
5
POWER INPUT CONNECTOR (4-Pin Molex)
Connect the enclosed Molex pigtail to the vehicle’s power,
ground, and back-up light circuits, (see Figure 3 on page 6).