User Guide

MS3001 / MS3200 Installation Manual - Page 17
You can use this chart to quickly identify and interpret the MS3001 / MS3200 system’s chirp
indications and LED flashes.
The system continuously monitors all protected zones, even when it is not armed, and warns
you if it detects a problem when you turn off the ignition.
1. Turn off the ignition.
2. If the siren chirps twice, the system has detected a problem.
3. The status LED will flash to indicate the zone where the problem has been detected.
1 flash = door
2 flashes = Shock Sensor
3 flashes = optional sensor
4 flashes = hood / trunk
Full Time System Diagnostics
Reference Chart
1 chirp arming normal arming
1 + 3 chirps arming Shock Sensor sensitivity is off
1 + 4 chirps arming door, hood, or trunk is open
2 quick chirps arming Valet Mode is on
LED double flashes Valet Mode Starter Defeat Activated
2 chirps disarming normal disarming
1 Long + 1 Short Chirp disarming Tamper Alert - system was triggered
no LED flashes after Tamper Alert ignition
1 LED flash after Tamper Alert door
2 LED flashes after Tamper Alert Shock Sensor
3 LED flashes after Tamper Alert optional sensor
4 LED flashes after Tamper Alert hood or trunk
1 chirp while armed Warn Away
5 quick chirps while armed Dedicated Remote Start Mode
activated
Double chirps 1 minute after disarming Automatic Rearming
(for 10 seconds)
LED flashing quickly ignition key off Passive Arming sequence started
Two chirps ignition key off Full Time System Diagnostics
1 LED flash after Full Time Sys. Diag. door
2 LED flashes after Full Time Sys. Diag. Shock Sensor
3 LED flashes after Full Time Sys. Diag. optional sensor
4 LED flashes after Full Time Sys. Diag. hood or trunk
Output When Status
install_MS3001.qxd 8/11/99 4:15 PM Page 17