Technical data

Remote Transmitter Layout
Each MS1001 system comes with 2 multifunction Remote Transmitters used to control nearly all
of the system’s features.
Each time a transmitter button is pressed, the LED will flash to indicate that a transmission is
taking place.
Button 1 Arms and Disarms the system. This Button also locks and unlocks the doors when the
system is in Valet Mode.
Button 2 controls the system’s Auxiliary Function 1, which is normally used for activating a car’s
electric trunk release.
When Button 1 and 2 are pressed together, the system will Arm or Disarm
silently (without chirp
confirmation).
As an option, your installer can set system to always arm without chirp confirmation. If this is done, then
pressing Buttons 1 and 2 together will Arm or Disarm the system with chirp confirmation.
It is also possible to set individual Remote Transmitters to arm and disarm the system using
either of the Transmitters function Buttons, which is useful when a Transmitter is used to control
two systems. See
Adding a Remote Transmitter into the System.
Remote Transmitters
Button 1
Button 2
LED
Page 2 - MS1001 Owner’s Manual
MS1001_owner's.qxd 8/23/99 6:06 PM Page 2