Installation manual

-9-
10. Plug-in Connectors
4-PIN WHITE CONNECTOR
Plug-in connector port for dual stage shock sensor.
2-PIN BLUE CONNECTOR
Plug-in connector port for Valet/Override button.
2-PIN RED CONNECTOR
Plug-in connector port for LED indicator.
4-PIN WHITE CONNECTOR
Plug-in connector port for optional dual stage sensor such as an additional dual
stage shock sensor, glass breakage sensor, or dual zone proximity sensor..
3-PIN BLUE CONNECTOR
Plug-in connector port for optional Ungo-Net devices.
11. Programming Remote Transmitters
Prior to programming new remote transmitters to the security system, make sure to
have the desired transmitters ready.
11.1 To Enter Remote Transmitter Programming
To Enter Remote Transmitter Programming:
1. Turn the ignition ON, OFF, ON, OFF, and leave ON.
2. Press and hold the Valet/Override switch for 5 seconds.
The siren will chirp once.
3. Press the Lock button on the transmitter.
The siren will chirp once.
4. Press the Lock button on the transmitter again.
The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional transmitter.
6. Turn OFF the ignition when transmitter programming is complete.
The siren will chirp 3 times.
11.2 Two Car Remote Operations
The 5-button remote transmitter is capable of controlling two vehicles with a single
remote transmitter. To program the primary remote transmitter to the second
vehicle, make sure to have the desired transmitter(s) ready.
MS2106 install.qxd 6/25/2003 10:53 AM Page 9