Installation manual

-7-
8. Wiring Information
8.1 Main 16-Pin Harness
BROWN: (+) Siren output 3A.
Connect to the siren's red wire. Connect the black wire of the siren to (-) chassis
ground. (It is recommended to ground the siren at the same point as the main unit.)
BLACK: (-) Ground input.
Connect this wire to bare metal, using a lock or star washer to prevent the screw
from coming loose. If possible, use a factory bolt, rather then a screw.
ORANGE: (-) Armed output 500mA.
This wire provides a ground output when the unit is armed. This wire can be used
to activate an optional circuit interrupt or other device (i.e.: window module, etc).
BLUE/BLACK: (-) Optional sensor input.
Connect this wire optional sensor, such as a hood pin switch or additional sensor.
YELLOW: +12V ignition input.
Connect to the main ignition wire at the ignition switch. This wire must show + 12V
when the ignition is ON and while the vehicle is cranking.
BROWN/WHITE: (-) Horn Honk Output 500mA.
Connect to a relay to pulse the horn when the security system is triggered. (See
Horn Honk Relay Diagrams for assistance.)
YELLOW/VIOLET: (-) Auxiliary 3 output 500mA.
Connect to a relay for an optional feature such as a linear actuator, headlight circuit,
window module, or etc. The Auxiliary 3 output can be programmed for momentary,
timed, or latched activation.
YELLOW/WHITE: (-) Auxiliary 1 output 500mA.
Connect to a relay for an optional feature such as a trunk release solenoid, window
module, headlight activation, etc. The Auxiliary 1 output can be programmed for
momentary, timed, or latched activation.
WHITE: (+/-) Parking light output (10A relay).
The output polarity of this circuit can be selected for either (+) positive or (-)
negative output via the internal jumper. Make sure to verify the polarity of the
parking light circuit before setting the jumper.
RED: +12V Battery input.
Connect to the vehicle's positive battery terminal and add a fuse within 12 inches.
BLACK/WHITE: (-) Dome light supervision output 500mA.
Connect to a relay for optional dome light supervision upon disarming the security
system. (See Dome Light Supervision diagram for assistance.)
MS2106 install.qxd 6/25/2003 10:53 AM Page 7