Installation manual
-13-
14.1 Installer Parameter Descriptions
1.
Door Unlock Pulse:
Selects between single or double unlock pulse.
2.
Door Lock Pulse Width:
Selects between a 1-second or 3-second door lock
pulse.
3.
Passive Locking:
Selects whether or not the door locks will automatically lock
with Auto Rearming and Passive Arming.
4.
Door Entry Delay with Passive Arming:
Selects whether or not the door
trigger input will be delayed for 15 seconds, allowing access to the Override
switch. The door trigger is delayed only when the system arms passively.
5.
Ignore Dome Light Delay:
Selects whether or not the security system will
ignore the door trigger for 20 seconds upon arming. For vehicles with timed
dome light delays, the system will not detect a faulty door trigger upon arming.
6.
Siren or Horn Chirps:
Selects between siren chirps or horn chirps.
7.
Horn Honk / Alarming Output:
Selects whether the Brown/White wire will
pulse or be continuous when the alarm is sounding. In continuous mode, it can
be used to trigger an interior siren (a pain generator). (Parameter 12 must be
set at default mode: Horn Output)
8.
Auxiliary 1 Output:
Selects between momentary, timed, or latched output for
Auxiliary 1.
Momentary: Provides an output that will remain active as long as transmitter
button is depressed.
Timed: Provides an output that will remain active for 30 seconds.
Latched: Provides an output that will activate when the transmitter button is
pressed and remain active until the the transmitter button is pressed again.
The latched output can be programmed to reset when the security system is
Armed or the ignition is turned On. (Requires the Ungo-Net computer interface
for programming.)
9.
Auxiliary 2 Output:
Selects between momentary, timed, or latched output for
Auxiliary 2 (see step 8 for descriptions).
10.
Auxiliary 3 Output:
Selects between momentary, timed, or latched output for
Auxiliary 3 (see step 8 for descriptions).
11.
Auxiliary 2 Activate on Arm:
The security system can be programmed to
activate Auxiliary 2 when Armed. This feature can be used to turn on a piezo
warning indicator, roll up windows, etc.
12.
Trunk Disarm Feature:
This feature will automatically disarm the security
system when Auxiliary 1 is activated.
MS2106 install.qxd 6/25/2003 10:53 AM Page 13