Installation manual

-12-
4. Within 5 seconds, press the transmitter button corresponding to the desired
operating mode that Parameter.
The siren will chirp corresponding to the button depressed.
5. When finished, turn the ignition OFF to save changes.
13.3 Default Reset for User Programming
1. Turn the ignition ON.
2. Within 5 seconds, press the Valet/Override button 2 times and hold for 2
seconds.
The siren will chirp, indicating that Programming has been entered.
3. Press transmitter button 3.
The siren will chirp 6 times indicating the reset signal has been received, and
User Parameters have been reset to factory default.
14. Installer Programmable Parameters
Installer Programming Table
1. Door Unlock Pulse Single Double
2. Door Lock/Unlock Pulse Width 1 Second 3 Seconds
3. Passive Locking Off On
4. Door Entry Delay w/ Passive Arming Off On
5. Ignore Dome Light Delay Off On
6. Siren / Horn Chirps Siren Only Horn Chirps
7. Horn Honk / Alarming Output Pulsing Continuous
8. Auxiliary 1 Output Momentary Timed Latched
9. Auxiliary 2 Output Momentary Timed Latched
10. Auxiliary 3 Output Momentary Timed Latched
11. Auxiliary 2 Activate on Arm Off On
12. Trunk Disarm Feature Off On
13. Program RPM Learn RPM Gas Diesel
14. 2-way Transmitter Module Learn Module ID Learn Transmitter ID
Step 13 is reserved for use with Ungo-Net Start Module.
Step 14 is reserved for use with Ungo-Net 2-way LCD transmitter module.
Feature Button 1 (default) Button 2 Button 3
MS2106 install.qxd 6/25/2003 10:53 AM Page 12