Installation manual

-10-
Programming the primary remote transmitter to the second vehicle:
1. Turn the ignition ON, OFF, ON, OFF, and leave ON.
The siren will chirp 3 times.
2. Press and hold the Valet/Override switch for 5 seconds.
The siren will chirp 5 times.
3. Press Button 5 twice followed by the Lock button on the transmitter.
The siren will chirp once.
4. Press Button 5 twice followed by the Lock button on the transmitter again.
The siren will chirp twice.
5. Repeat steps 3 and 4 for each additional transmitter.
6. Turn OFF the ignition when transmitter programming is complete.
The siren will chirp 3 times.
12. Programmable System Parameters
The Ungo MS2106 has 2 independent programmable parameter tables. One
parameter table is for User's and the other is for Installer (see chapter 12). These
parameter tables can be modified using the Ungo-Net computer interface (part #:
PCLink) or by using the Valet/Override button. The Ungo-Net interface allows for
additional custom features and settings not accessible through the Programming
Table.
13. User Programmable Parameters
User Programming Table
1. Arming Mode Active Passive
2. Auto Rearm On Off
3. Arming Chirps Normal Silent
4. Ignition Controlled Door Locking On Off
5. Ignition Controlled Door Unlocking All Doors Driver’s Door Off
6. Override Code Programming Code Set
7. Remote Start in Valet Mode Enabled Disabled
8. Automatic Starting Disabled Temperature Start Voltage Start
Steps 7 & 8 are reserved for use with Ungo-Net Start Module.
Feature Button 1 (default) Button 2 Button 3
MS2106 install.qxd 6/25/2003 10:53 AM Page 10