User`s manual

CLARION M10 SERIES TESTING
M10 SERIES USER’S MANUAL PAGE 41
radio is set to use the Clarion null address instead of its own MAC ID,
the radio’s MAC ID must be used for remote access. To allow a
broadcast address to be used over the air would require handling
multiple responses, which is not possible. The command will
automatically flow through the sending M10II to the remote M10II and
the response will occur back throughout the sending M10II. The re-
transmission protocol will also work as in the case of any normal
packet. Remote M10IIs can be queried, and reconfigured. Using
Tmshow, you can view the remote M10II’s table entries. For security
purposes, the remote configuration is disabled by default. If you want it
on, you must enable it locally through the AUI port only. Once enabled,
all activity can be controlled remotely but this way the configuration can
only be changed after someone within the user’s facility has allowed it.
Commands that cannot operate remotely include: firmware upgrade,
enabling M10II mode/licensing, and enabling remote commands.