Model K10 ➤Owner’s Guide
limited lifetime consumer warranty This Ungo Pro Security system is warranted against defects in material and workmanship. The main unit is covered by this limited lifetime warranty. This Limited Lifetime Warranty applies to Ungo Pro Security systems that have been installed by an authorized Ungo Pro Security dealer. This warranty is to the Original Purchaser ("Owner") and to the original vehicle in which it was installed into. This warranty is not transferable to any subsequent owner(s) of the product(s).
TO USE OF THE PRODUCT. BECAUSE SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS OR EXCLUSIONS OR LIMITATIONS OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, THE ABOVE LIMITATIONS OR EXCLUSIONS MAY NOT APPLY TO YOU. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE THE OTHER RIGHTS, WHICH VARY FROM STATE TO STATE.
table of contents limited lifetime consumer warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .i standard remote configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 what is included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 important information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 system maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
standard remote configuration controls the Arm function. controls the Disarm function. controls Silent Arm/Disarm and an Auxiliary Output. controls the Panic function. and 2 pressed together control an Auxiliary Output.
what is included z The control module z Superhet receiver z A pair of four-button remotes z The blue status LED indicator light z A push-button override switch z Starter Kill Relay important information Congratulations on the purchase of your alarm/keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by anyone other than an authorized dealer voids the warranty.
fcc/id notice This device complies with Part 15 of FCC rules. Operation is subject to the following conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device.
Button The unlocking/disarming function is controlled by pressing this button for one second. Button Silent Arm/Disarm and an optional auxiliary function are controlled by this button. (An optional auxiliary function, such as trunk release, can be controlled by pressing this button for 1.5 seconds.) The auxiliary output controls __________________________. Button The panic feature is controlled by pressing this button for one second.
using your system locking/arming Pressing for one second arms the system by activating the starter kill and locking the doors (if connected). The horn will honk (if connected) and the parking lights will flash once to confirm arming of the system. While the system is armed, the status LED will flash once per second. The Starter Kill (if installed) will also prevent the vehicle’s starter from cranking. note: Manually locking the vehicle does not arm the system; it will only lock the doors.
unlocking/disarming Pressing for one second disarms the system and unlocks the doors (if connected). The horn will honk twice (if connected) and the parking lights will flash twice to confirm disarming of the system. The optional Starter Kill will be deactivated. The status LED will turn off, unless the system is programmed for Passive Mode. In Passive Mode, the status LED will flash rapidly when the system is disarmed.
disabling the system without a remote If your remote is lost or damaged, you can manually override the system. To do this, you must have the vehicle's ignition key and know where the Override switch is located. Be sure to check with the installer for the location of the Override switch. To disarm the security system, turn the ignition to the ON position. Press and release the Override switch within 10 seconds. The status LED will stop DRW-35 flashing and the vehicle should start.
override mode You can prevent your system from automatically activating the Starter Kill and locking the doors by using override mode. This is very useful when washing the vehicle or having it serviced. In override mode, the starter kill cannot be activated, even with the remote, but all convenience functions (door locks, trunk release, etc.) will continue to work normally. To enter or exit override mode: 1. Turn the ignition on. 2. Turn the ignition off. 3.
individual recognition Individual recognition is a feature available. Using the Pro Security Programmer, a hand-held programming tool, your dealer can program many of the system settings. The programmer makes it possible to program different settings for each remote that is used with the system. Then, whenever a specific remote is used, the system will recall the settings assigned to that remote.
programming options Programming options control your system's normal, operational set-up. Most options do not require additional parts, but some may require additional installation labor. This system's programming options are listed below, with the factory default settings in bold: z Passive Mode or Active Mode. In Passive Mode the Starter Kill will automatically activate 30 seconds after the ignition has been turned off. z Ignition switch-controlled door-locking on or off.
glossary of terms Control Unit: The “brain” of your system. Usually hidden under the dash area of the vehicle. It houses the microprocessor that monitors your vehicle and controls all system functions. LED: A blue light mounted at a discretionary location inside the vehicle. It is used to indicate the status of your system. Starter Interrupt: An automatic switch controlled by your system which prevents the vehicle’s starter from cranking whenever the system is armed.
Domelight Supervision: The domelight will illuminate for 30 seconds each time the system is disarmed using the remote. This is useful for seeing inside the vehicle at night prior to entering it. Power Door Lock Control: Your system is capable of controlling many types of power door lock systems; however, some door lock systems may require extra parts. Consult with your dealer to determine which type of locks your vehicle uses.
14
✂ QUICK REFERENCE GUIDE Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet. To lock/arm using your remote ➤ To arm the system press for one second. The doors will lock (if connected). The LED will begin to flash. The Starter Kill will prevent the vehicle’s starter from cranking if it has been installed. The vehicle’s horn (if connected) will honk and the parking lights will flash once to confirm arming of the system.
Get Started Get Protected Ungo Pro Security 661 W. Redondo Beach Blvd. Gardena, Ca. 90247 800-GO-CLARION © 2003 Directed Electronics, Inc.
