Owner`s manual

34
English
FZ709
When code is registered
3 - 3 .
Slide along
[ ]
slider or touch
[ ]
/
[ ]
key to input the registered code.
3 - 4 .
Touch
[ ]
/
[
]
key to set the previous or
next digit.
Note:
Write down your personal code in case you forget
it.
3 - 6 .
“MEMORY XXXX” will be displayed for 2 sec-
onds where “XXXX” is the entered digits.
3 - 5 .
During finish adjustment, touch
[
ENT
]
key
for 2 seconds to memory the new setting
value.
Common Operations
Setting the beep
∗
The factory default setting is “ON”.
3 - 1 .
Select “BEEP”.
3 - 2 .
Touch
[ ]
key to enter detail setting stage.
3 - 3 .
Slide along
[ ]
slider or touch
[ ]
/
[ ]
key to select “ON” or “OFF”.
When no code is registered
3 - 3 .
Slide along
[ ]
slider or touch
[ ]
/
[ ]
key to adjust the value.
3 - 4 .
Touch
[ ]
/
[
]
key to set the previous or
next digit.
Setting the code
3 - 1 .
Select “CODE”.
3 - 2 .
Touch
[ ]
key to enter detail setting stage.
Notes:
If both the dimmer and the car’s illumination are
turned on, “ILLUMI ON” and the adjustment value
will be displayed. If the dimmer is turned on and
the car’s illumination is turned off, “ILLUMI OFF
”
and the adjustment value will be displayed.
If the dimmer is turned off, only the adjustment value
will be displayed.
The display brightness level setting during dimmer
and car’s illumination are turned on has indepen
-
dent adjustment value.
Downloaded from Caradio-Manual.com Manuals