Operation Manual

63
4.5.6 Warning settings
You can enable some handy warnings, and disable the touch screen in a moving vehicle with Safety
Mode. Tap the following buttons:
, , .
Button Description
Warn When Speeding
Maps may contain information about the speed limits of the road
segments. Clarion EZ Drive is able to warn you if you exceed the
current limit. This information may not be available for your region,
or may not be fully correct for all roads in the map. This setting lets
you decide whether you wish to receive the warnings or not. You
can set the relative speeding at which the application warns you
(100% is the current speed limit):
• In Built-up Areas: in cities and towns
• Elsewhere: at all other locations
Speed Camera Warning
This feature allows you to receive a warning when approaching a
Road Safety Camera. You must ensure on your own liability that
using this feature is legal in the country where you intend to use it.
You have the following options:
• Audible Warning: beeps can be played while you are
approaching the camera, or just alert sounds if you exceed
the speed limit while approaching one of these cameras.
• Visible Warning: the type of the camera and the controlled
speed limit appears on the Map screen while you are
approaching one of these cameras.
Warn if Too Fast for a Pedestrian
Enable this warning to be alert if pedestrian mode is activated and
you drive fast. You are asked if you want to change to car
navigation mode. This way you can be sure you will not be routed
via one-way roads in the wrong direction as a pedestrian could, for
example.
Safety Mode Safety Mode will disable the touch screen while the vehicle is
moving to keep your attention on the road. You cannot set a new
destination or change settings.
4.5.7 GPS settings
You can set up the connection to the GPS receiver. Tap the following buttons: , ,
.
Button Description
GPS receiver ...
The first line of the screen informs you about the connection status of
the GPS receiver.
Connecting the GPS receiver is automatic in Clarion EZ Drive, so
normally you will not need this screen of settings at all.
GPS Enabled
Turn the connection to the GPS receiver on or off. Turning off the GPS