Operation Manual

16
Icon Information Details Action
position. position, the view of the
sky above you is shown
with colored dots for each
satellite. Some dots need
to turn green to be able to
navigate.
If the icon is a static
picture, route
calculation is needed
GPS position and an
active route are available,
but automatic off-route
recalculation is switched
off, and you deviated from
the route.
Tap this area to make Clarion EZ Drive
recalculate the recommended route.
If the icon is
animated, route
calculation is in
progress
Clarion EZ Drive is
calculating or recalculating
the route.
Nothing happens if you tap this area of
the screen.
,
Next route event (next
maneuver)
GPS position and an
active route are available,
and you navigate the
recommended route. This
area gives you information
about the type and
distance of the next route
event.
Tap this area to open the Route
Information screen.
The following area appears next to the above described rounded area. When tapping this area, the
result depends on the information currently shown.
Icon Information Details Action
No GPS signals
detected
If there is no valid GPS position,
this symbol appears here.
Tap this area to open the GPS Data
screen to check the signal status or the
connection settings.
Traffic restriction When GPS position is available,
but there is no route to be
navigated, the traffic restriction
of the upcoming intersection is
shown here if there is any.
Nothing happens if you tap this area of
the screen.
,
Second route
event (maneuver
after the next
maneuver)
When GPS position and an
active route are both available,
this field shows the route event
that follows the next route event
shown in the above described
area.
Tap this area to open the Itinerary
screen with the turn by turn guidance
instructions.
Approaching a
Road Safety
Camera
This icon appears when you are
approaching a Road Safety
Camera, and the warning for
cameras is enabled in Settings.
Tap this area to suppress the audible
camera warning.
Stops the
running
simulation
This icon appears during Route
Fly Over, Route Simulation, and
Track Log playback.
Tap this area to stop the simulation.
Route
recalculation
progress
During route recalculation, this
field shows the recalculation
progress between 0% and
Nothing happens if you tap this area of
the screen.